Installing on AIX |
Top Previous Next |
Prior to installation it is recommended that you review the Installation components section to determine what components you will require.
ZIP Console Installation
JSCAPE MFT Gateway Server
To install using the ZIP file perform the following steps as a user with root privileges.
1.Place the install.zip file in a directory on the destination server.
2.Install. Run the following commands from the directory containing the ZIP file you placed on your server:
unzip install.zip
3.AIX systems are typically configured to run the IBM JVM, therefore it is necessary to make some changes to the etc/ssl.cfg file in order to instruct the JVM on what security provider and encryption algorithm to use for starting up the JSCAPE MFT Gateway Service. See Running under IBM JVM for complete details and instructions. 4.Add administrative user. Go to the JSCAPE MFT Gateway installation directory relative to where the tar command was executed, and run the following command:
./add-administrator -u [username] -p [password]
For example:
./add-administrator -u admin -p secret
This will configure JSCAPE MFT Gateway, where [username] and [password] are the administrative credentials you will use when connecting to the service.
5.Startup Administration Service. From the JSCAPE MFT Gateway installation directory run the following command:
./server start
JSCAPE MFT Gateway Agent
1. Place the install.zip file in a directory on the destination server.
2. Install. Run the following command from the directory containing the ZIP file you placed on your server:
unzip install.zip
3. AIX systems are typically configured to run the IBM JVM, therefore it is necessary to make some changes to the etc/ssl.cfg file in order to instruct the JVM on what security provider and encryption algorithm to use for starting up the JSCAPE MFT Gateway Service. See Running under IBM JVM for complete details and instructions.
4. Enable control channel for JSCAPE MFT Gateway Server. See Control channel settings for details.
5. Set agent connection settings. Go to the JSCAPE MFT Gateway installation directory relative to where the unzip command was executed, and run the following command:
./agent-configuration -host [ip] -port [port] -user [username] -pwd [password]
For example:
./agent-configuration -host 10.0.0.1 -port 30025 -user admin -pwd secret
This will configure JSCAPE MFT Gateway Agent, where [ip] and [port]are the control channel IP and port for JSCAPE MFT Gateway Server and [username] and [password] are administrative credentials you will use when connecting to the control channel.
6. Startup JSCAPE MFT Gateway Agent Service. From the JSCAPE MFT Gateway installation directory run the following command: ./agent start
See also
Launching JSCAPE MFT Gateway Manager
|