Installing on Linux |
Top Previous Next |
Prior to installation it is recommended that you review the Installation components section to determine what components you will require. Installation instructions for each component are provided below.
RPM Console Installation
JSCAPE MFT Gateway Server
Note: Several Linux distributions exhibit slow response as a result of the newly introduced FIPS TLS library. To prevent this issue, please install haveged before installing JSCAPE MFT Gateway
To install using the RPM file perform the following steps as a user with root privileges.
rpm -iv gateway_install.rpm
./add-administrator -username [username] -password [password] -email [email]
For example:
./add-administrator -username admin -password secret -email admin@jscape.com
This will configure JSCAPE MFT Gateway, where [username] and [password] are the administrative credentials you will use when connecting to the service.
./gateway start
or
./start_service.sh
JSCAPE MFT Gateway Agent
1. Place the gateway_agent_install.rpm file in a directory on the destination server.
2. Install. Run the following command from the directory containing the RPM file you placed on your server:
rpm -iv gateway_agent_install.rpm
3. Enable control channel for JSCAPE MFT Gateway Server. See Control channel settings for details.
4. Set agent connection settings. See Adding agents for details. From the /opt/JSCAPE_MFT_Agent directory run the following command:
./agent-configuration -host [ip] -port [port] -user [username] -password [password]
For example:
./agent-configuration -host 10.0.0.1 -port 30025 -user admin -password secret
This will configure JSCAPE MFT Gateway Agent, where [ip] and [port]are the control channel IP and port for JSCAPE MFT Gateway Server and [username] and [password] are administrative credentials you will use when connecting to the control channel.
5. Startup JSCAPE MFT Gateway Agent Service. From the JSCAPE MFT Gateway Agent installation directory run the following command: ./agent start
ZIP Console Installation
JSCAPE MFT Gateway Server
Note: Several Linux distributions exhibit slow response as a result of the newly introduced FIPS TLS library. To prevent this issue, please install haveged before installing JSCAPE MFT Gateway
unzip gateway_install.zip
./add-administrator -username [username] -password [password] -email [email]
For example:
./add-administrator -username admin -password secret -email admin@jscape.com
This will configure JSCAPE MFT Gateway, where [username] and [password] are the administrative credentials you will use when connecting to the service.
./gateway start
./start_service.sh
JSCAPE MFT Gateway Agent
1. Place the gateway_agent_install.zip file in a directory on the destination server.
2. Install. Run the following command from the directory containing the ZIP file you placed on your server:
unzip gateway_agent_install.zip
3. Enable control channel for JSCAPE MFT Gateway Server. See Control channel settings for details.
4. Set agent connection settings. See Adding agents for details. Go to the JSCAPE MFT Gateway Agent installation directory relative to where the unzip command was executed, and run the following command:
./agent-configuration -host [ip] -port [port] -user [username] -password [password]
For example:
./agent-configuration -host 10.0.0.1 -port 30025 -user admin -password secret
This will configure JSCAPE MFT Gateway Agent, where [ip] and [port]are the control channel IP and port for JSCAPE MFT Gateway Server and [username] and [password] are administrative credentials you will use when connecting to the control channel.
5. Startup JSCAPE MFT Gateway Agent Service. From the JSCAPE MFT Gateway Agent installation directory run the following command: ./agent start
See also
Launching JSCAPE MFT Gateway Manager
|